Em-Trak R100 Manuel télécharger pdf (Page 15)

Installation

Page 12

Chart plotter

To display received AIS messages from other vessels on your chart plotter, you will need to

connect your AIS transceiver to your chart plotter. Please refer to the user manual supplied with

your chart plotter for details of how to connect and configure your chart plotter for use with AIS

devices. For general guidance your chart plotter should be configured to accept NMEA data at

38400 baud (sometimes referred to as 'NMEA HS' in the plotter configuration menu). You may

also need to enable the display of AIS targets in the chart options.

Alternatively if you use an NMEA2000 network on your vessel it is possible to connect the AIS

transceiver to the NMEA2000 network via a suitable cable. Please refer to your dealer for details

of NMEA2000 cables.

Connection to a PC

If you choose to use a PC with suitable charting software to display received AIS messages as

other vessels, this can be accomplished by connecting the USB connector on the unit to the PC

via the supplied USB cable.

GPS antenna mount

A one inch 14 TPI pole mount is required to mount the supplied GPS antenna. Please contact

your dealer for details of suitable products.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Pas de commentaire

Em-Trak R100 Manuel Page 15